Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi there, Bought a 2004 1.4 307 (manual) Needed a bit of work doing and hubbys a mechanic, all work has been done other than drivers side drive shaft, he says the driveshaft slipped in, went well, put/changed 1ltr of gear oil in it, now it will go into gear BUT wont drive and crunches into reverse, any ideas on what or how it can be fixed??? It drove fine before other than the nock of the driveshaft.

All help and advice is much appreciated, Thanks
 

·
Registered
Joined
·
369 Posts
Wrong drive shaft?
I had this on mine it also dropped the oil. In my case it was only a few mm out the shaft went in but didn't make contact on the splines.
 
1 - 3 of 3 Posts
Top