Peugeot Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,932 Posts
Take the big black pipe off and see what it is like in there. Engine cold and stationary by the way. If signs of oil then try rocking the shaft in up and down and fore and aft motions to see if there is any play.
 

·
Registered
Joined
·
11 Posts
Discussion Starter #3
It's a brand new turbo new seals feed pipe etc all oil flushed just coming out of the breather pipe and don't know why mate
 

·
Registered
Joined
·
5 Posts
Sounds like back pressure....Open the cap where you put oil in and see how much pressure there is....hopefully no smoke
 

·
Registered
Joined
·
14,880 Posts
This is a common issue on these there is a flap to stop oil coming out that closes under load but it rarely works properly so they tend to leak some into intake and burn it its not an issue unless its a river :)
 

·
Registered
Joined
·
5 Posts
There is oil coming out of this pipe is this normal it's going into my new turbo apso took the maf off today to clean as oil was on there and now I'm getting anti pollution error code on dash
Go to a shop where sell o-rings and rubbers,buy one oring that fit.
I already done that with sucess,but loose pic with size of oring.
 
1 - 7 of 7 Posts
Top