Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Had a problem with the waste gate actuator position sensor shorting to earth which in turn blew the 5 volt side of the ecu!, when removed the actuator on the sring side was full of water!!!! thus causing the short, have dryed it all out and replaced sensor and had ecu repaired and car is running fine.
any ideas as what can cause this as im scared it could happen again......
 

·
Registered
Joined
·
10 Posts
Discussion Starter #2
Nobody ??? After trawling this forum and google I cant find anything, just cant understand how it could happen :confused:
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
well basically ive refitted it, is it watertight?? that ill have to wait and see, this is of course if its the actuator itself leaking, which i doubt as its new or somehow water it getting in the system some other way.
Im totally at a loss to see how a sealed vacum system can get water in :confused:
 
1 - 4 of 4 Posts
Top