Peugeot Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Please help!
After replacing the clutch, I cracked the differential housing while torquing the bolts. To replace it I had to remove the engine bracket, right side wheel/brake/drive shaft. After replacing the housing and putting everything back together I was left with this:
Glove Gig bag Leather Personal protective equipment Jacket


I can not for the life of me figure out where it goes, but I suspect it has something to do with the engine suspension/brackets, since it feels like the engine wobbles when I start it up.

Any help and/or tips are much appreciated!

Thank you!

Edit:
The car in question is a 2005 Peugeot 307 SW GRIFFE 2.0
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Looks like a subframe bolt to me
Thank you for your reply!

I just looked over the subframe, I can't find any missing bolts. Also, I have not been doing any work on the subframe. I only removed the parts connected to the drive shaft so that I could replace the differential housing.

Any other ideas?

Do you want me to take pictures of any parts?
 

·
Moderator
Joined
·
9,522 Posts
The only other long bolts I can think of in that area are for the rear mount and it's torsion bar

Sent from my SM-G935F using Tapatalk
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top