Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Hi, I could really use some help! I took my 307 SW (2007) into the garage for the A/C to be recharged and to have the heater blower motor replaced. The works were done but the garage said I needed to replace the climate control display because the AC button isn't working/doesn't connect to the pump...

I have got as far as moving the ash tray and undoing the Torx screws, but from there I don't know how to remove the central silver housing around the display.

Can anybody walk me through how to remove the display so I can replace it with the second hand one I purchased?

Any help much appreciated!

Thanks!
 

·
Moderator
Joined
·
12,076 Posts
Radio and that little cubby hole underneath it need to come out.

Also lift up the gearstick gaiter and that rubber pad below the ashtray.

You'll then find more Torx screws and see the clips.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Thanks for your help!

Managed to swap the display out, AC seems to work fine now - wonder if anyone else has had this problem that the AC button doesn't communicate with the pump?

Just an absolute nightmare to get the plastic surround back on the dash - only managed one side so far...
 
1 - 3 of 3 Posts
Top