Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
My heater motor dont work.shall the be constant voltage on the plug on blower motor , the plug some have read and black wire. This is a 307 sw 2005 With Automatic climacontrol , this motor have inbuilt resistor. i have no voltage on the read wire. And dont find wiring diagram for this , the wiring in the fuses Box dont have 12 voltage , i omh from fuse Box to the red wire , and find 2 wires som are conected to the red , but no voltage on they and the 40A fuse is ok, so i Wonder if that are a rely somewhere .Are in norway and nead the heater for driving the car.
Share
Share this post on Digg
Del.icio.us
Technorati
Twitter
 

·
Registered
Joined
·
3 Posts
Discussion Starter #2
I have find this , i download this Peugeot Virtual machine and get all wiring and diagram , it is big file , but very useful. The 12 v is controled of one relay in the fuse Box.. Link to :

PEUGEOT
 

·
Registered
Joined
·
344 Posts
Hi,

If you've not already done so, check the positive wire at the blower with the ignition on and blower switch turned on.

If no voltage then likely the relay/fuse is at fault.

If you have voltage, the blower is at fault.

If all these are fine then the only remaining part is the switch on the dash itself.
 
1 - 4 of 4 Posts
Top