Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Hi,
My gear linkage cable has broken, I've managed to disconnect both ends of the cables but there is a bracket of some sort at the gearbox end, could anyone tell me how to remove the cable from this bracket , is it some sort of clip holding it into place ?

ta :)
 

·
Registered
Joined
·
1,054 Posts
It is a C shaped clip with a lip in the middle of the C that is holding the outer cable to the control plate on top of the gearbox. Use a sharp screwdriver and tap it out from above with a hammer with the screwdriver tip acting on the lip, not easy but once the clip starts moving it's obvious how it works.
Yes it will fall out but they are relatively easy to retrieve.
 
1 - 2 of 2 Posts
Top