Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
248 Posts
Discussion Starter #1
307 HDI 51 plate

I have this 'anti pollution fault' and the car is in limp mode.

I'm waiting for the Lexia pp2000 diagnostic to arrive, but thought I would tinker whilst i waited.

The car would drive in safe mode - but not much past 3000 revs before it stalls. I've notice lately that it struggles to get past 2000 revs, but starts and idles fine.

So i wondered if it was the fuel filter. I unscrewed the drain plug at the bottom, but nothing came out :confused: - even with it totally removed. Took the filter off the car and drained it from the top hoses. Quite a bit of floaters in it.

So i'm wondering if the filter is blocked.... ;) or is this usuall
 

·
Registered
Joined
·
248 Posts
Discussion Starter #3
Clean out the what.... cung.? :confused:

I think mine is the sealed one - unless it can spring open somehow
 

·
Registered
Joined
·
302 Posts
lol sorry the gunk,, it has three pipes on top which you press a little clip and the come off a clip with a wire then the outer bit justs un twists
 

·
Registered
Joined
·
248 Posts
Discussion Starter #5
All done.

Car is now running OK with no limp mode. 'anti pollution fault' still on though :mad:

Had to buy a filter with the sensor already fitted. Apparently there has been some cock up at Motoquip and they haven't made the port long enough on their replacements :rolleyes:
 
1 - 6 of 6 Posts
Top