Peugeot Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Does anyone know of an easy way of routing a cable from inside the engine bay to the inside of the car? My car is a 407 SW 2.2HDi sport xs.
I have fitted a front parking sensor to protect my front spoiler and the only way I could find to route the cable was to run the cable via the front passenger door, this is ok for now but I would like to find a way of getting the cable fitted more permanently.
If anyone has a solution please let me know.
 

·
Registered
Joined
·
1,002 Posts
its very hard to get behind the engine bay to get the wire through one of the rubber seals.. best way is to get the wire to run through the wing near the door loomb and into the car..
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Do you mean on the outside of the car in the gap between the panels then in through the passenger door. As I have done this already but I was hoping I could find a more permanent route. Any ideas?
 
1 - 3 of 3 Posts
Top