Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Could anyone give me a step-by-step guide on fitting one of these Parrot hands free kits to a 307? I don't want to go cutting wires and dismantling the dashboard to find I've done it wrong! :D
 

·
Moderator
Joined
·
5,886 Posts
I fitted a parrot MKI9200 to my 307 with RT3 (which is not listed in compatible table). I used a universal parrot iso cable and modded it by moving the 12V perm supply to the correct wire (I used the RD4 to RT3 upgrade guide to ID the correct pin/cable)

I then used the glove box light to supply the switched 12V supply this makes it shutdown correctly when ign is switched off,(if you use the BSI switched supply to the radio the Parrot takes about 4 mins to switch off)

Hope this helps, if needed i can see if i can get a picture of the cable

I fitted the parrot control unit to the side of the heater box by glove box ran the cable up the side of centre console and fitted the unit to the side of heater vent
 
1 - 5 of 5 Posts
Top