Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
Hi All my friends has 2012 Peugeot 308 sw with the 1.6 hdi 112bhp engine. When you start it up after about 10 seconds information light comes on with engine fault repair needed and goes into like a limp mode and reduced power. I have an autel diagnostic tool which is bringing up a few codes p1434 p1435 and p1445 p1445 is saying additive system. Additive in particle emission filter max threshold other faults seem to be pointing to additive pump open circuit or additive pump fault or fluid to high. The car has done 118000 miles I am thinking may be the dpf needs replacing but with me using the autel diagnostic and not the lexia diagbox I can't look into pump or dpf with the autel tool. Has anyone had these fault codes and what was the outcome cheers
 
1 - 1 of 1 Posts
Top