Peugeot Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
hi, can you help me. I have had a new engine fitted to my peogeut expert 2.0hdi taxi. But ever since the engine refit i have not been able to get any heat into the front or rear of the cab.

I was wondering if it is a pipe problem, being put on the wrong way. If any one can help me with a diagram then i would be most gratefull.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #5 ·
hi, the vin is (removed for safety). Have warm water going to the right side of the matrix pipe, but no hot air in cab.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #7 ·
right, followed the diagram, hot water is getting to the t connection but no further. After several hours of bleeding still nothing in the cab. The pipes going into the matrix are both cold.
 
1 - 7 of 7 Posts
Top