Peugeot Forums banner
1 - 2 of 2 Posts

· Registered
217 Posts
Discussion Starter · #1 ·
Hi just swapped a engine in my expert and I'm having trouble with the exhaust the 2 pins on the manifold slot into the exhaust the the springs go over the pins and bolt it up just doesn't seem tight enough any idea guys? I'm sure there were washers of some sort on the old one I can't remember.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.