Peugeot Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter · #1 · (Edited)
and specifically the three plugs that go into the Sagem ECU

Looks like its one of the 3 plugs that go into the ECU that has been causing all my issues.

I've found a secondhand wiring loom on eBay, but does anyone know if its possible to buy just the plugs that go into the ECU, who they're made by, part no etc?

Here's hoping

Regards all
 

·
Registered
Joined
·
60 Posts
Discussion Starter · #3 ·
Just been talking to an ECU specialist firm, seems connector issues are very common and they fix them by cannibalising second hand looms and re-using the pins (sockets) in the plug.

My problem is definitely the plug as you can make the fault come and go by gently moving the plug around in the socket. (Throttle stepper motor)

Its a bastard as the car runs so well otherwise, only done 40k miles.
 

·
Registered
Joined
·
60 Posts
Discussion Starter · #4 ·
Just in case anyone is following this thread or using it to solve their own problems....

Replaced the connector on the loom and it DIDN'T fix the problem, exactly the same problem(s) as before, inc wiggling the plug and the engine revs going up & down.

So the ECU is now off to an ECU specialist.....
 
1 - 4 of 4 Posts
Top