Peugeot Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
:mad::mad:hi buddy ive a partner 03 ive replaced the engine with a 306 Dturbo unit with a front mount intercooler its running well my problem is when i start the engine the battery light stays on and after about 3 mins all the electrics in the van shut down ie/ guages lights mostly every thing engine stayes running as we wired the stop solinoid any ideas or proper ecu wiring diagrams as may just be simmply a live to the ecu or somthing any help would be much apreciated thanks
 

·
Registered
Joined
·
14,878 Posts
You need the crank sensor in the gearbox connected to the ecu as this sends the signal to the BSI that keeps it out of economy mode without a crank signal it goes to sleep
I KNOW this is whats wrong as my son done the very same conversion :)
 

·
Registered
Joined
·
14 Posts
Discussion Starter #3
aaarrrhhh

thanks for your prompt reply reliable406 should i use the sensor off the 306 unit or the one off the dw8 unit thanks
 

·
Registered
Joined
·
14,878 Posts
You need the dw8 sensor and the dw8 ecu still connected to the main loom it then stays awake and the battery light should go out if it does not the alternator may not be compatible with the charging system in the BSI
 

·
Registered
Joined
·
14 Posts
Discussion Starter #7
think we sorted it

from what i have found on berlingo forum i have got to change the flywheel and put the dw8 flywheel on the engine as the 306 flywheel dosent have a pickup for the eco mode setup on the mk2 partner because it has a bsi/ecu will get the engine out on the weekend and fit dw8 f/w



FINGERS CROSSED
 

·
Registered
Joined
·
14 Posts
Discussion Starter #8
hopful

ok update report think we sorted it had to remove engine again cracked the gearbox back off
the 306 flywheel has the pickup onthe back of the f/w it has two drilled holes now the dw8 engiine has two big lugs on the oposite side and are oposite each other they locate in tow drilled locating holes but the clutch off the 306 engine is larger and wont fit the dw8 f/w didnt want to use the smaller cutch as im a bit heavy footed Big Grin an it wouldnt take the abuse
i moddified my 306 f/w fitted the pickup lugs into the holes i drilled and welded them just to be sure just have to fit it all back to the car over the weeknd an see what happens Idea Idea
 

·
Registered
Joined
·
14,878 Posts
Yea that's the issue I forgot he changed his flywheel to a gti 180 1 for the sensors but what you have done was my original suggestion for his im glad he used the 180 one though as I then sold his old flywheel :)
 

·
Registered
Joined
·
14 Posts
Discussion Starter #10
FINALY SORTED


finaly sorted after much head scratching and swearing ive done it van runing battery light out and ECU staying awake
was the square pegs on the fly wheel WELLL HAPPY
 
1 - 10 of 10 Posts
Top