Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi All.

I'm new and need some help please.

Yesterday my Peugeot 207 had messages flash up:

ABS Stop
Anti Pollution fault
Power Steering gets heavy
Speedometer says --------

I get a STOP light too. The brakes work perfectly (they were only checked a month ago)

With my insurance I have breakdown service, they came out and used their C Reader to check and had:

P0500 Vehicle Speed Sensor (VSS) Circuit
P1351 Ignition Coil Control Circuit High Voltage
U0121 Lost Communicaton with Anti Lock Braking System (ABS) Control Module

The faults all said pending so they cleared the codes and said I needed a new ABS ECU Unit. I drove home and nothing went wrong. I drove to the Supermarket and back, about 6 miles this mornng and still clear of fault. Just as I was reversing up the back lane to my house (on cobblestones) it happened again but JUST the ABS warning message this time.

I have scoured the web and others have had this problem, there seems to be enormous costs involved, BSI Resets suggested, possible Vehicle Speed Sensor loose down to the wheels.

I am convinced it is just sensor(s) on the wheels, and I assume there is a speed sensor wire that goes there and it is linked to the ABS because of the P0500 error.

I am contacting my usual garage in the morning but wanted to know if any one had any thoughts please.

Thanks in advance
 

·
Registered
Joined
·
3 Posts
Discussion Starter #2
Started to find lots of info on this so thread can be deleted.

I don't think I can delete it though as I cannot see an option.
 
1 - 2 of 2 Posts
Top