Peugeot Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter #1
My car is a 2003 2.2HDI 807 and i bought an new n/s CV joint from ECP as mine was clicking. But it won't fit on the shaft, the center hole is too small and it also won't fit in the hub, the splines don't seem to line up. But this is the only one ECP list for this car, so are there two different sizes.

Thanks
 

·
Moderator
Joined
·
6,000 Posts
There are two listed on service box

3273 TG DRIVE-SHAFT NEW RIGHT MARKING 8MN23 8NN81 - UNTIL RPO 09961

3273 HV or 3273 TG RIGHT SINCE RPO 09962
 

·
Registered
Joined
·
30 Posts
Did you just look on their website or did you ring them?
Website wrong on more than a few occasions.
Ring around a few diff ones like Andrew page etc.
This car is getting old so less and less bits stocked now and left to the dealer to get.
 

·
Registered
Joined
·
2,470 Posts
Post the last eight characters of the VIN. Then one of us can look up the correct part no and you can use that to search on EBay if you don't want to buy from the dealer.
 

·
Registered
Joined
·
134 Posts
Discussion Starter #8 (Edited)
Ok phoned around and they all list just one and i think they are the same as the ECP one, which is wrong. Went to my local French breakers with my old one and he matched it up, not put it on the car yet. But he told me there are definitely two sizes. Will put VIN on here later, just to get a part number etc.

Thanks

OK the shaft fits perfectly and has 27 splines hub side, where as the others all had 28
 
1 - 8 of 8 Posts
Top