Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Hi everyone was wondering if anyone can tell me if my 2011 partner tepee outdoor 112hp 1.6hdi has an oil feed pipe and banjo bolt to the turbo??? Im at 110,000 miles. Have read about pipes clogging and stopping oil feed to turbo. Also been told these models have problems with injector seals that cause carbon build up within the engine.

Anyhelp or advice would be great. Just looking to prevent disaster if possible. Car is well maintained.

Thanks.
 

·
Moderator
Joined
·
5,624 Posts
Its not the pipe that causes the main issue it was a small screen filter fitted in the banjo bolt that used to clog and restrict oil flow.

I think they changed the filter and deleted it from some models. The Garratt fitting instructions for a replacement turbo used to recommend replacing the pipe and not fitting a filter
 

·
Registered
Joined
·
70 Posts
There is a big discussion on this forum about removing this filter, as advised in a Service Bulletin. Bit of searching should find it!
 
1 - 3 of 3 Posts
Top