Peugeot Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
2,506 Posts
Discussion Starter #1
Had the "service, engine fault" come up on the 308 yesterday.
My generic EOBD reader wouldn't communicate with the engine ECU so got out the laptop (after charging it up) and did a global scan with that.
Came up with 2 faults on th engine ECU, bit stated ECU not recognised.
Going into the ECU for more information I get presented with a list of possible ECUs.
OK, with a bit of trial and error, I eventually found one which listed the faults, one referred to a dual mass flywheel fault.
Anyway I erased all the faults, and so far they haven't cme back.

My Diagbox has updates to 7.62, the car is a 2015 model (see my signature).

Would a later update be more useful for this car, and if so has anyone got it, or where would I get a copy?
 

·
Registered
Joined
·
449 Posts
Updating to 7.83 should allow ECU to be recognized. But you will lose ability to telecode settings in BSI. That's why I use virtual machine, and have both versions, one which can telecode BSI (7.53 I think), and the latest available 7.83 for everything else.
 

·
Read Only
Joined
·
126 Posts
Uploaded them here:


Here's the key:

_WcyWdH6TrYEDEVUVH2mHQ
A big thank you Gibbo,
I had 7.62, with 7.66 I now see my 308 's' the 308s wasn't there before.
I assume all the updates just cover newer vehicles and not software changes?
Thank you
jb
 

·
Registered
Joined
·
2,506 Posts
Discussion Starter #7
Unfortunately 7.76 still won't recognise the engine ECU on my 308.
Not bothered about telecoding, but do need to be able to read fault codes and delete them.

Is the update to 7.83 available anywhere?
 

·
Registered
Joined
·
2,506 Posts
Discussion Starter #10 (Edited)
Well that didn't go quite to plan.
Installed update, but DiagBox still says 7.76.

Problem, supposed to rename three folders, but I was unable to do this with the Ediag folder as it is in use. Checked processes in Task Manager, and couldn't find what to stop. Found one psa process and stopped that, but not enough. Also stopped eclipse.
Any clues as to what the various processes are which need stopping?
 

·
Registered
Joined
·
2,506 Posts
Discussion Starter #11
OK, update.
Couldn't stop all processes, so rebooted in safe mode, then I was able to rename ediag folder.
Went through the update proceedure, rebooted, then ran Diagbox.
Still says V7.76.

So I'm a bit lost now. I'll check it in the car in the morning to see if anything has changed.
 
1 - 11 of 11 Posts
Top