Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3,446 Posts
Discussion Starter #1
to cut a long story short. purchased a laptop with xp and installed planet

no issues for 2 years and worked perfectally.

decided i needed newer software, upgraded to windows 7 and installed diagbox

installed xp mode with planet but wouldnt connect to the car

installed vmware which wasnt much good

looked at dual booting the laptop but kept getting blue screens

connected the diagbox to my missus car but says pp2000 referenced on the engine ecu. it never did this on planet with the same cable

i have managed to get through to the ecu manually but its a pain

any ideas why this is. i get alot of make sure lexia is connected have to undo the usb and reattach a few times which is a pain

any ideas guys
why are these not easy
 

·
Registered
Joined
·
556 Posts
Thinking back, i may have had this on my lexia:-( had it on my ids vcm1 which was the lan cable failed :-( hope this isn't a hardware fault with the lexia?? :-(
 

·
Registered
Joined
·
3,446 Posts
Discussion Starter #4
has anyone ever had the problem i have on diagbox.

when i click into peugeot planet it says the lexia is being used by another program. i guess this is diagbox.

you have to go back and uplug and replug in the interface a few times. its so annoying you dont get this on a standalone pp
 

·
Registered
Joined
·
556 Posts
Have you looked in task manager?
I got 4 hours sleep :-( got w7 on an atom netbook and installed diagbox 7.02 but when i put scary01 in it installs the extra things then says no registration start again (something like that) :-(
 
1 - 5 of 5 Posts
Top