Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
196 Posts
Discussion Starter #1
I've been fitting an RT6 to my car (upgrade from RT3). I need to change some setting in it with Diagbox, but so far all I get is ECU not recognised.

I've upgraded from 7.02 to 7.57 and still getting the same error. I'm going to keep updating, but if anyone has successfully connected to the RT6, can you confirm what version of Diagbox you're on!

Cheers. If I get this sorted I took lots of photos so I'll make a tut for anyone who wants to do the same.
 
1 - 1 of 1 Posts
Top