Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
First off, hi everyone, newbie on the site looking for help. Have got a de-pollution fault on the dash. Looked through the rest of the forum but not found anything the same. Have checked with an OBD11 connector and the fault code of P118F comes up, changed the sensor at the fuel cap as that was coming up too. Also have had all 4 injectors checked and they fine. What and where is the pressure sensor in the exhaust as this been mentioned too???

Any help would be appriciated as the the car is fine till it gets to running temp, then goes beep and dies.
 

·
Registered
Joined
·
406 Posts
you need to get it hooked up to planet mate. Some generic OBD11 codes are very mis leading. What age is the car?
The pressure sensor senses differential pressure across the particulate filter (assuming we are talking about a 110bhp version?).
If that is coming up then it is worth cleaning the filter out. I did a guide for that based on a 52 plate 307. just follow the link below.



http://homepage.ntlworld.com/marc.z/index.html/Peugeot Files/
 
1 - 3 of 3 Posts
Top