Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
437 Posts
Discussion Starter #1
Trying to trace a coolant leak at the rear of my engine - 2.0 HDI 110.

Does anyone know where the coolant pipe goes after it leaves the top of the EGR cooler? It seems to go towards the bottom of the engine and then run underneath turbo and back towards passenger side?

Hoping to get a better look tomorrow.

Ignore red arrow it's a borrowed pic.

Cheers
Pete

 

·
Registered
Joined
·
437 Posts
Discussion Starter #3
Yeah bottom outlet from EGR Cooler goes to heater matrix.

The top outlet does a 180 and goes towards the bottom of the engine and then seems to disappear. I just wondered where it goes from there?

Cheers
 

·
Registered
Joined
·
3,423 Posts
mine is leaking too i could feel the pipe but access is no good.

im sure mines leaking from a pipe with a clip so it must be the bendy one. its only started leaking since i did my clutch.

ive tried a tiny bit of radweld in mine as it only drips
 

·
Registered
Joined
·
437 Posts
Discussion Starter #5
Gonna have another look if it stops raining.

I currently have no driveshafts or intercooler pipe on it so might be able to get in from underneath.
 

·
Registered
Joined
·
437 Posts
Discussion Starter #6
Well even with no driveshaft or intercooler pipe it was a b*tch to get to and get off, mostly because of the pressure clips that Peugeot use.

Still not obvious where it was leaking from but I will be replacing all pressure clips with jubilees.

Here's a layout of the hoses if anyones interested. Bottom rubber hose goes into a solid metal pipe that goes across to the passenger side of the car:

 
1 - 6 of 6 Posts
Top