Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
248 Posts
Discussion Starter #1
I am going to change the coolant after the winter snap. Can someone tell me where the bleed screws are on a 307 HDI 1.4 51 plate.

Or, can i just add it to the expansion bottle and run the car without the top, so the car pushes the air out itself.
 
D

·
Guest
Joined
·
0 Posts
One bleed screw is on pipes going into bulkhead. Think from memory there is one near thermostat housing. Fill bottle and rev to 1500rpm until fans come on. Do this after bleeding out fresh coolant from each bleed nipple.

Sent from my GT-S5690
 
1 - 3 of 3 Posts
Top