Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi not sure if anyone could give me an opinion on this my vans a 2007 Expert 1.6hdi and recently I had a fluid leak where the pipe goes into the slave cylinder. Attempted to replace the slave cylinder but the pipe disintegrated soon as I began to remove it. Ordered and fitted a new pipe from Peugeot, new slave cyl from Euro car parts approx £30 for the cylinder? All been good for about a 1000 mile checked the oil the weekend and noticed that ive got signs of fluid leaking around the pipe union again & also on the bleed nipple. It's not dripping fluid levels good but u can see it's 'wet'. I was careful on fitment not to snag the seal & lubed it with a bit of fluid? The clutch has good bite but isn't as light as it could be so could the pressure be causing a problem or am I best to try a genuine peugeot slave cylinder?

Regards AL
 
1 - 1 of 1 Posts
Top