Peugeot Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,045 Posts
Discussion Starter #1 (Edited)
clutch or the clutch slave cylinder

driving the car this morring and went to take off in 1st gear the clutch pedal was vibrating and kinda stuck for a wee sec till i rev the car took of now there is a squeaking noise could this be the clutch or the clutch master cylinder its not the flywheel as its solid one, there is a rubbing sound as well
 

·
Super Moderator
Joined
·
1,760 Posts
If you're anyway talented mechanically you should be fine!
 

·
Registered
Joined
·
1,045 Posts
Discussion Starter #4
Stevo was thinking that since ive ball joints drive shafts, discs pads gear linkages ect i could do this,

was talking to a few guys today and they think i could get away with just doing the bearing just as the clutch would be fine i dont know any ideas?:confused:
 
D

·
Guest
Joined
·
0 Posts
Waste of time, put a clutch kit in it. I'll bet the pressure plate will be damaged by the release bearing!
 

·
Registered
Joined
·
4,506 Posts
im with david on this. my thrust bearing went in my 307...bought a clutch kit under strong recommendation from garages and people in the know...how gutted would you be if you replaced the bearing and had to take it all apart again to replace pressure plate.:thumb:
 

·
Super Moderator
Joined
·
1,760 Posts
Ach there's another ween o' miles in thon yet!
 
1 - 8 of 8 Posts
Top