Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1 (Edited)
Made a bit of a cock-up,
I need a new clutch, but decided that I could still use my van for a little longer if I was to back-off the peddle stop, in so doing the clutch arm would press on the clutch plate a little heavier,
however all that has happened is that the auto-adjuster has taken up the slack and I'm back to square one :rolleyes:
so now if I set the peddle stop back to its normal position I get no clutch at all.
when I get the clutch done I will also have to get a new cable at a cost of £50+ plus fitting..... unless someone knows if it is possible to reset it.

thanks for your help,

and stop laughing :(

forgot to say, van is a mk1 Expert 1.9td
 

·
Registered
Joined
·
46 Posts
hi see it the adjuster unit is right at the end of the cable think it may push thrue the bulk head on the inside look for were the cable comes thrue the centre is the control push it in that should do it
 
1 - 2 of 2 Posts
Top