Peugeot Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter #1 (Edited)
Camshaft position (CMP) sensor

where is it located on 1.6HDI, asume its on the drivers side (UK) lower of engine.
Got p3008 come up twice which I think is the following:
Camshaft position (CMP) sensor - signal limit exceeded

Is it just replace, any idea on price.
 

·
Registered
Joined
·
115 Posts
Discussion Starter #3 (Edited)
This is my problem with not having PP2000, I can't trust the codes I'm getting, hoped to pick one up at the weekend but seller was away. Also had P0100, which showed MAF.
After cleaning EGR on Saturday it was running fine, now my mpg has dropped back to 31 again and it's smoking at about 2000 to 2500 rpm.
I will have to check my refitting of the servo was correct.
 

·
Registered
Joined
·
115 Posts
Discussion Starter #4 (Edited)
What position should the pin be in the valve at low revs, is it all the way left at the bottom of the ramps or fully clockwise at the top of the ramp. I didn't check when I took it off which position was closed.
Going to pull servo off when I get home to see what's wrong.
 
1 - 8 of 8 Posts
Top