Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
Recently, my windshield was replaced (not by the dealer). It seems that both the light and rain sensors react a bit differently now. Especially the light sensor reacts slower; in tunnels it takes a few seconds to turn on the lighting.

Should these be calibrated again? I saw such a function in Diagbox, but did not dare to use it yet. Can this be done at home, or is special equipment (besides Diagbox) needed?
 

·
Registered
Joined
·
138 Posts
Recently, my windshield was replaced (not by the dealer). It seems that both the light and rain sensors react a bit differently now. Especially the light sensor reacts slower; in tunnels it takes a few seconds to turn on the lighting.

Should these be calibrated again? I saw such a function in Diagbox, but did not dare to use it yet. Can this be done at home, or is special equipment (besides Diagbox) needed?
I have looked through the whole of PP and have never found where to can set reset the sensors.
Mike
 
1 - 2 of 2 Posts
Top