Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
hi
my peugeot `107 failed mot on corroded brake lines going into the wheel cylinders on both the rear rear wheels can someone tell me the way to bleed the brakes once l renew the brake lines,l have read so many posts on this saying about air in abs and pedal going spongy after bleeding etc so would like any good info on how to do the job properly so l can get my car through mot thnx in advance
 

·
Moderator
Joined
·
6,451 Posts
Take cap off brake fluid reservoir and put a bag, rubber glove or cling film over top and replace cap. Change pipes and remove bag etc then bleed brakes as normal and you should be fine.

Sealing off the cap should stop fluid siphoning out and get air into master cylinder side of ABS pump.

Sent from my SM-G935F using Tapatalk
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
hi windy many thnx for your reply l will let you know how l get on also do you know the sequence of the brake bleeding on these cars many thnx
 
1 - 3 of 3 Posts
Top