Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
Hi, I am sure other people have raised this in the past but has anyone done a stage 3 upgrade on a 2.0 HDI engine?

If so, what figures did you achieve in the bhp/torque department?

What uprated fuel pump did you put in, FMIC, turbo upgrade etc??

I currently have a stage 1 set-up on a 2.0 110 HDI 307 (running 125bhp/325Nm at the min to protect the DMF as starting to squeak) but have been toying with the idea as I have a SMF/uprated clutch to fit in the near future and have been offered a hybrid turbo....:)
Looking into it I have seen that with an agressive set-up it can achieve around 190bhp, 400Nm etc...:thumb:

Any advice/details would be appreciated.

Thanks
 

·
Registered
Joined
·
4,506 Posts
ive not seen anyone on the forum mention this before so i think responses are going to be a little few and far between. but there could be someone with a little knowledge that may help :thumb:
 

·
Registered
Joined
·
238 Posts
anything over 160bhp on the 110 you will soon knacker the gearbox due to the torque stress on it, so i have been told on some other forum. best bet is have a word with hdi_tuning on this forum.
 
1 - 4 of 4 Posts
Top