Anti Pollution Fault - Please Help
Hi, I was hoping someone could help with my anti pollution fault problem on my Pug 307 1.6HDI Quicksilver 54 Plate.
I've spent over 1k at the garage to no avail. Spent on new Fuel Sensors and Liters of 'Peugeot' fuel additive for diesel engines. I'm now very reluctant to go back to the garage as i'm sure they are just ripping me off.
When the anti pollution light came on the car would go into Limp mode but after a few miles would be back to normal. Now though it wont go over 2k revs. On a motorway for example going up a hill it will go from 70mph to 45mph as it feels as though the boost has gone.
I read on your forums to take the air filter sensor out as this could be the fault. I did this and the car ran much better and didnt go into Limp. I ordered a new Air Sensor, fitted it and the same error happened.
I've now bought my own diagnostics gadget and I've received the following errors:
- P0104 Mass or Volume Air Flow A Circuit Intermittent
(Your Forum said: MAF (Mass Air Flow) ground malfunction)
- P0113 Intake Air Temperature Sensor 1 Circuit High
(Your Forum said:Intake air temperature (IAT) sensor circuit open/short EDC16C3 - Diesel high pressure regulation circuit. Rail pressure below minimum pressure.)
- P0299 Turbo Charger Underboost
(Your Forum said: For SID 803; Check vacuum supply to controller solenoid, they have been known to leak vacuum.
I have seen an EDC16C3 system with a recked turbo.)
- P1447 Manufacture Control
(Your Forum said: For EDC15C2; Check for inverted pipe configuration on differential pressure sensor or water ingress)
- P2408 Fuel Cap Sensor / Switch Circuit
(EDC16C3 - Additive system. Fuel tank cap presence sensor. All the tank cap present sensors I've tested, so far, should read:
149Kohms = cap on, 12~15ohms = cap off.)
- P1351 Manufactuer Control (For SID 803, check the operation and output of the pre-heat control relay.)
Looking on more of these threads it looks like the Turbo Charge error is coming on due to the air filter sensor. I just need to figure out why the Air Filter Sensor is coming on.
Please can anyone shed any light on what would be best to do next. Or even better, can someone suggest a good honest Mechanic. I live in South West London but travel down to Surrey a lot.
Thank you for reading this
