Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
I have a 2010 2l hdi expert teepe and want to remove the anti roll bar. Will it through or will I have to drop subframe as I have been told I might need to. I bought a bush kit but not sure if it's correct. If I'm try and fail to fit it I will put a new bar on the same day as I can not be without the bus

Thanks martin
 

·
Registered
Joined
·
14,284 Posts
You cannot easily get it out cut the old bushes open keep the top half of the metal bracket buy the bushes for the previous model expert never do them again :)
 

·
Registered
Joined
·
147 Posts
The problem I had was separating the two halves of the bracket. they are swaged together. I cut through the middle of the top half of the bracket with a long hacksaw blade and was able to swivel the both bits through 90degs to remove the bracket complete and replace with new brackets supplied in the kit. The kit I had was the one with poly bushes....lasted forever. I take your point though Reliable regarding using the older type bushes, it's just getting the old bracket off that's the problem.

https://www.ebay.co.uk/itm/FOR-PEUGEOT-EXPERT-TEPEE-E7-FRONT-ANTI-ROLL-BAR-BUSH-IN-POLYURETHANE-REPAIR-KIT/231070631031?_trkparms=aid=555017&algo=PL.CASSINI&ao=1&asc=20151005190705&meid=ee1ca68aa2b54fd7b0940678b279f4e0&pid=100506&rk=1&rkt=1&&itm=231070631031&_trksid=p2045573.c100506.m3226
 
1 - 4 of 4 Posts
Top