Peugeot Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
307 2.0 petrol are getting anti pollution in 1-2days after resetting dtc's.

Here are errorcodes.


Coils and coilpack is all new and original. Any ideas?
 

·
Registered
Joined
·
60 Posts
Ignition intergration msg, start with the permenant messages. Plugs any good? I believe it can be caused by that, was the coil pack a good set?
If you Google the messages you'll find a lot of those messages already asked.
Let us know what you find.
 

·
Registered
Joined
·
60 Posts
Most likely it's a good one, if it were me I'd Google the other messages and make a note of the possible causes.
I think I'd also put some new plugs in it. It could be the wiring to the coil pack, worth a good look.
How does the car run?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #7
Car runs fine no problem. Get's a little low on rpms when you brake down now and then but mostly runs perfect. Plugs are under 2 months original from peugeot
 

·
Registered
Joined
·
60 Posts
I believe that would be the MAP sensor.
Are you getting any pressure readings on PP?
There's one on the measurements that shows a reading in mb for inlet pressure, in ECU parameter measurement
On a 1.6 petrol it's at the rear of the rocker cover in line with the pug badge attached to the fuel manifold. Held with one bolt.
Couldn't say for a 2 Liter but they are cheap on ebay.
 
1 - 9 of 9 Posts
Top