Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi All

I have a TS4 2001 where the AC compressor won't start. when i use the PP2000 Tester it says that the data cable is defectiv. but when i test the AC compressor it self it clicks with the magnet clutch.

Can i make a manual switch that starts the compressor? Is it just to connect a switch to the main leed and then to the compressor or is something else needed?

-regards from Denmark

Stig Madsen
 

·
Registered
Joined
·
5,916 Posts
The compressor clutch won't engage if the system needs regassing. There is a pressure sensor which disables the system if the pressure drops usually due to needing a regas to protect the compressor as the gas contains a lubricant for the pump. Fitting an external switch could result in the compressor seizing up due to lack of lubrication.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Ok super

The former owner had it regased just get told that the link between BSI box and compressor was bad. but i'll get it topped off and see if helps. :)
 
1 - 3 of 3 Posts
Top