Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Found today I have at least one dodgy electrical conection at the ABS pump wiring connector. Has any one got any idea how it comes apart?
 

·
Registered
Joined
·
3 Posts
Discussion Starter #2
An update for everyone. I found that the pins can be removed by taking the main slider off and removing a secondary slide that acts as a securing device. I used a needle to slide under where the pin is located and pushed up the securing tab. You carn't see any of the pin but once you get the first one out its obvious how they are held in. I found I had 4 connectors that were very loose and could rotate on the male connector. In side the connector there are 2 fingers that press on the male connector and hold it in place. Again I used a needle to very gentle re profile the fingers so they connected better. It's all back to normal and working.
 
1 - 3 of 3 Posts
Top