Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,912 Posts
Discussion Starter #1
replaced sensor as had a C1326 no communication error with left rear sensor

now got C1327 error no description as soon as turn over car

checked gap it was too big so knocked away the corrosion and seems ok now

error still appears

Any ideas?

Thanks

Robbie
 

·
Registered
Joined
·
139 Posts
How much corrosion have you knocked back? I had to file mine back until the sensor was just less than 1mm away from the ring.

Failing that it could be the cable from the sensor connector to the module.
 

·
Registered
Joined
·
5,904 Posts
Found this for C1327. May help.

C1327/C1337For Bosch ABS/ESP with active sensors, this fault code can be generated for sensor or harness open circuit, or signal coherence. On 307's it is often caused by the air gap increasing too far due to corrosion under the sensor where it is mounted on the hub support.

Guess you've already attended to the gap part.
 
1 - 3 of 3 Posts
Top