Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi all, I have replaced the front ball joint and bushes on the drivers side of my 2003 307sw 2.0hdi. I unplugged the abs sensor to remove the hub and pushed the caliper piston back in slightly to allow the refitting of the pads. Now I have the abs and esp warning lights on all the time. Does anyone know if pushing the piston in has damaged the ABS unit, or what the best way of tackling this is? thanks Nigel
 

·
Registered
Joined
·
4,506 Posts
you might have messed up the air gap on the abs sensor when you removed it. it should have 2mm air gap between it and the ring. i would double check that first (cheapest)
 
1 - 2 of 2 Posts
Top