Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
171 Posts
Discussion Starter #1
307 2.0 hdi 8 valve

During my recent rebuild I found that three of the four injector seals were stuck fairly solid in the head. Tried for ages with screwdrivers and the like, attacking them from top and bottom but I couldn't shift them.

In the end I found that a head bolt from the same engine is the perfect fit to screw into the copper seal, providing a good firm grip, allowing me to wiggle and pull out the seals with ease.

What's cool is that this method works if the head is still fitted though you should source a spare head bolt or find one of similar size, don't take one out of the block if they're not being removed anyway!

Hope this helps someone :)
 
1 - 1 of 1 Posts
Top