Peugeot Forums banner

1 - 10 of 10 Posts

·
Moderator
Joined
·
6,581 Posts
What engine, ECU, and software version. do you have your Ori file as its best to map the original file
 

·
Moderator
Joined
·
6,581 Posts
You will need a galletto cable or similar (assuming EDC15 ecu) to read your engine ECU flash, there are 3 or 4 different software versions and you will brick ECU if you write the wrong file back to your ECU

If once you downloaded the flash if you post it here or send it to me by PM (Conversation) I maybe able to De-FAP for you.

You will then need to write new file back to ECU and change BSI settings with lexia to Fuel Additive ECU Absent
 

·
Moderator
Joined
·
6,581 Posts
Simplest way is to look at the label on the front of ECU it should list type, hardware and software versions.

Lexia displays hardware and software version and im sure from that the version will be obvious
 

·
Registered
Joined
·
75 Posts
Discussion Starter #7
OK thanx, the label is worn out on the front so I'll need to plug it in.
My son has a mpps v16 cable he mapped his vrs with, would this work the same as the galleto cable.
 

·
Moderator
Joined
·
6,581 Posts
MPPS should work if its EDC15 (which i think it will be)
 

·
Registered
Joined
·
75 Posts
Discussion Starter #9
OK thanx. I was gonna do the 170bhp map but at £100 it's not viable as I'll be scraping the car in the near future, assuming we still have one. ?
 
1 - 10 of 10 Posts
Top