Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hi all!! I'm getting around to fitting the AL4 I bought earlier this year (doesn't take me long you know) and I'm going to try and lift and bring the engine forward if I ever get the exhaust bolts out, there so damned tight. I was hoping for some advice on the drive shafts, do they just slide out and do I disconnect the bottom ball joints to get them out. Any other advice on this mammoth job would be appreciated, Best Regards, Bob.
 

·
Registered
Joined
·
14,956 Posts
Disconnect the 2 bolts holding the hub to the strut and the shafts come out the hub and the box bottom balljoint is too hard.

If you are pulling the whole engine and box out you really only need to pull the passenger side out as the drivers side will slide out on the way out still on the engine.
 
1 - 3 of 3 Posts
Top