Peugeot Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
I have finally got my window back together and it worked fine before I put the door card back on. When I first put it on it wouldn't wind all the way down with one push, but the next day it did. But on the wind up, not only does it not wind up with one pull, to wind it up I have to pull the switch and it goes up about 2 inches then release the switch and repeat the process several times until it is fully shut.
 

·
Registered
Joined
·
15,376 Posts
once its shut hold the switch in the up position for 10 seconds then it should work properly
 

·
Registered
Joined
·
33 Posts
Discussion Starter · #3 ·
Thanks for the reply, I have tried it with the ignition and with it off but its still the same. I got it wrong in my post, it only goes up about an inch each time and it takes eleven pulls to get it up.
best regards,
Joe
 

·
Registered
Joined
·
15,376 Posts
Needs reset as above or the anti pinch is stalling the window due to drag in the runners

Reset with ignition ON it may take a few tries for it to work especially if the switch is dicky as a lot are
 
1 - 4 of 4 Posts
Top