Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi has any one converted from 4 stud to 5 stud or is there any threads that have done this already
 

·
Registered
Joined
·
9 Posts
Discussion Starter #2
Ok after a little bit of research iv noticed that citreonbitter are quite similar if not the same as Peugeot so I'm thinking of buying a c4/c5 hubs and seeing if they would fit what do people think?
 
G

·
Guest
Joined
·
0 Posts
You may also need to check the hub nut sizes, brake disc diameter, caliper fixings ( if the 5 stud discs are bigger ) and if the rear discs have a handbrake system that will match your existing set-up.

I would also like to convert my 406 to 5 stud, and fit nice 407 alloys but to be honest I can't be arsed....
 

·
Registered
Joined
·
14,266 Posts
Rears would be reasonably easy as most vans are 5 stud but front could be a problem as 5 stud hubs tend to have the bigger shafts and brakes

There is probably something out there to do the job though.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #5
I have found a conversion kit on eBay but it costs 250and it just bolts on to the original hub I will post a link up
 
1 - 5 of 5 Posts
Top