Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi everyone. My old 407 SW seems to be a bit off now.. everything just dandy but no start though its cranking. problem started last year in a nice drive on the countryside.. just went silent with dead engine.. No coughs or performance problems, just dead. After several batterycharges and startattempts i gave up and pushed it behind the barn. Took it out a month ago .. charged the battery and it started after half a second. Runned like a charm for a month and died again today. same thing. cranking but no avail.

work so far.. DiagBox 7.02
codes=U1118,P1693,U2001,P0337,P0089,P0002

Parameters check gives no RPM and NO SYNC motor speed sensor

So .. suggestions , where to start ?

car recently (2 years ago) got new clutch, flywheel and FAP so i´m expecting some more mileage out of it :)

/Regards Ingemar
 

·
Registered
Joined
·
9 Posts
Discussion Starter #2
OK... so .. found it. The contact to crankshaft sensor accesible through right hand wheel arch soaked with wd40 and rinsed with air. Had a similar problem 6 years ago.. had water in mentioned contact then .. and it went dead in minus temps. same cause different symptoms.
 
1 - 2 of 2 Posts
Top