Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi I have a 406 hdi 110 that starts sometimes sometimes not, when trying to start it tries to fire but if it dosnt start at that first fire it wont start then I have to wait a couple of minutes and try again,
any help would be great
 

·
Registered
Joined
·
241 Posts
can you pump the 'bulb' in the fuel line-it sounds like an air leak...?
keep your foot to the boards too as this'll help let the air through/purge the air remember to let it off when it fires though.....just like if you replaced the fuel filter
neil
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
Thanks for the quick reply, it dosnt have a bulb it has a low pressure pump in the tank, when I try to start it its like one or two cylinders fire then it seems like some kind of sensor is telling it somethings wrong, when it does start it sounds a bit clattery
 

·
Registered
Joined
·
8 Posts
Discussion Starter #5
the pump in the tank works fine took the pipe of the filter turned on ignition diesel everywhere
 

·
Registered
Joined
·
8 Posts
Discussion Starter #6
hopefully I've found the problem a mate said it could your cam sensor, I took it out gave it a good clean made sure the air gap was set correct and it seems fine now hope this helps somebody else
 
1 - 6 of 6 Posts
Top