Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi. 1st time post - apologies if already discussed elsewhere. I’ve started to get “auto adjustment error” messages in the dash. Can anyone describe where the two sensors are please. Could these just be “dirty” or something? I was told by someone that they detect the axle height. ( Query IR or ultrasonic measurement) Thxs for any advice. Cheers. J
 

·
Premium Member
Joined
·
2,324 Posts
Two sensors, one on each axle.

It's a mechanical linkage between the sensor & the axle.

If you can wait till later this afternoon when I get home I'll have a look on Service Box for there locations.
 

·
Premium Member
Joined
·
2,324 Posts
Here you go - shows roughly where the sensors are located.

87358
 

·
Premium Member
Joined
·
3,023 Posts
You can clearly see the front one if you look behind the right front wheel at the back of the wishbone.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #5
Both. Thxs for taking the time to help me on this one. It really is appreciated. I’ll take a look and see if there’s anything obvious going on there. Rgds. Julian
 
1 - 5 of 5 Posts
Top