307CC Rear Sensor Trim/Insert
Join the discussion
Recommended Reading
-
FAP/DPF sensor 307 2,0 HDI 2002 RHS engine and
307Were is the FAP/DPF sensor 307 2,0 HDI 2002 RHS engine. I have change the partikel filter but even that i get a fault that says filter full so i whant try to change the sensor. If you have some picture also post them please. Get also a fault Pre/Post heating relay circuit. Blocked relay.- 7
- 53
-
2004 Peugeot 307 cc 2ltr MAF
307Hi,Could anyone tell me where the Manifold Pressure Sensor is. 307 COUPE CABRIOLET - 2 DOOR 2.0 i 16v 138 4-SPEED AUTOMATIC GEARBOX Petrol PRODUCT TYPE CAR COMMERCIAL MARQUE/COMPONENT TYPE PEUGEOT VEHICLE FAMILY 307 SILHOUETTE COUPE CABRIOLET - 2 DOOR TRIM LEVEL DYNAMIC ENGINE...- 1
- 45
-
Peugeot 307 2.0 80 kw 2001
307Hello guys, i have one question about my car. I think the dual-mass flywheel is near the end because i feel vibration in car when i start on and off. But first time when i feel that is today after my repairman put the new engine block carrier. ( I hope is just maybe that incorrect ) But in worst...- 2
- 87
-
Vuk307 · updated
-
307 won't start
307I've a 2002 307 1.4 diesel driving in heavy rain and deep puddles car was fine but then just cut out and now turns over but won't start have a feeling its a sensor that has got wet and is shorting out can anyone suggest where to look or what else might be good to test thanks- 2
- 108
-
Misfire on 307 1.4 petrol.
307Hi All, I have a mis fire and Mil on in my sons 2005 1.4 petrol 307. Code reader gives PO352 28 ignition coil fault. Clear the codes and replaced with good set of plugs and ignition pack from my other sons 307 car and the fault and symptoms and code re appear. Put lugs andpack back into the...- 7
- 167
Join now to ask and comment!