Peugeot Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hi all,
I am trying to remove the black strip in the rear bumper that has the sensors in.
A previous thread, (now locked) suggests this is easier than removing the whole bumper.
i just cannot find a way to get this strip off, where do I start?
i have not yet decided whether to replace the sensors one by one to find the bad one, or replace the whole lot with an ebay system, but either way I need to get that strip off,
thanks in advance
jason
 

·
Moderator
Joined
·
3,290 Posts
Looking at this damaged one..it looks like iys clipped in from the rear
90045
 

·
Registered
Joined
·
6 Posts
Discussion Starter #6
That’s very helpful, thanks Noddy.
i will investigate further based on that info.
best wishes
jason.
 

·
Moderator
Joined
·
3,290 Posts
Sorry i ment to say the clips are accessed from inside the rear of the bumper..
 

·
Registered
Joined
·
6 Posts
Discussion Starter #8
There is solid foam block stopping me from getting anywhere near these clips from behind. Do you think I need to take the bumper off? It was suggested in the other thread that this is not necessary. I only want to change a sensor or two!
 
1 - 9 of 9 Posts
Top