Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
119 Posts
Discussion Starter #1
Hi,

Can anyone shed any light on how to get at the "0" boot switch on the 307cc.
I'm guessing the trim has to come out but all of it ? or is there a knack to this

thanks
 

·
Registered
Joined
·
119 Posts
Discussion Starter #3
Thank Gibbo,

Have checked and read through but they are different .Its the access to the rear of the 307 cc badge that i need.

thanks anyway
 

·
Registered
Joined
·
119 Posts
Discussion Starter #4
for anyone who has a similar prob with the "0" switch , it can be removed quite easily . Best to remove the boot lid lining 1st then i found it easier to sit in the boot and slighly close the lid then with a torch you can prise the clip from the body work. Once disconnected you disconnect the plug. The only down side is the switch cannot be stripped down not
without damaging it.

Best to replace as a complete unit (£12.00 -ebay}
 

·
Registered
Joined
·
119 Posts
Discussion Starter #5
ok , so now changed for a new switch and its still not working. I'm guessing this is now a wiring issue but the wires go into a loom from the lights and look ok.
Would my pp2000 be able to trace or track to a fault ?

Thanks
 

·
Registered
Joined
·
119 Posts
Discussion Starter #6
Switch issue sorted.

Nothing wrong with the switch or wiring !!!!. Further research on here opened up " check the deadlock on the multi screen" just on the off chance .

Yep , ....deadlock activated. Unchecked and boot works as should.
Lesson learned ..........research, research......research.
 
1 - 6 of 6 Posts
Top