Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
Fitted a new offside front wheel bearing to the wife's 51 plate hdi which I purchased from my local factors the bearing was made by Premier with the magnetic ABS strip fitted to the bearing sealing ring. When the car was test driven found that the ABS was kicking below 30 mph above 30 mph seemed ok, the only time the light would come on if driven 30 mph or below for a short distance. I have changed the ABS sensor but has not made any difference, the only thing I have noticed is the air gap seems wide between the sensor and the magnetic ring and unable to reduce the gap on the front hub.
Has anybody come across this before or could it be a fault with the bearing or magnetic strip setup.:confused:
thanks in advance,
Shedman.
 
1 - 1 of 1 Posts
Top